Chinese
English
Русский
Español
National Service Hotline:
+86-372-2595077/2595078/2595088
Purpose
This series solenoid is applied to single-phase full wave rectifying DC power supply control circuits, which voltage can reach 220v, as a power component of the hydraulic solenoid directional valve. It can be used in NG6, NG10 screw connected solenoid directional valve of YUKEN.
Usual Service Conditions
● It can be installed randomly.
● There is no gas or dust which can corrupt metal or destroy nonconductor.Or,it will affect the products lifetime.
● The solenoids fit for the continuous duty system or intermittent periodic duty system.
● The reasonable wave range of supply voltage is between 85%-110%(any special requirements is possible).
● The protection is IP65 class.
Key Parameters
Code | MFZ9A-20YC | MFZ9A-55YC |
Rated Voltage (V) | 1224100220 | 1224100220 |
Rated Force (N) | ≥20 | ≥55 |
Rated Stroke (mm) | 3 | 4 |
Total Stroke (mm) | ≥6 | ≥8 |
Power consumption (W) | ≤28 | ≤38 |
Static Oil Pressure (MPa) | 16 | 16 |
Operating Frequency (T/h) | 12000 | 12000 |
Order Code
Valve-Using Solenoids | DC | Design Code | Rated Force(N) | Wet |
MF | Z | 9A | 20/55 | YC |
Steady Stroke-Force Curve
Externality &Installation Dimensions
MFZ9A-20YC
MFZ9A-55YC
Operating Notice
● The socket, which solenoids used, is according to ISO4400 standard. Including two specifications:indicator light &without light. You can choose according to your requirements. The voltage of the socket, with indicator light, must conform to the voltage of solenoid itself.
● The pushpin of the solenoid is used in adjustment or sometimes in emergency, but when the backpressure of the system is higher, please use screwdriver to push it, not strike it. The wallop can destroy the pushpin and the surface of the leading hole, or the solenoid will leak oil or cannot reposition.
● When solenoid is used in double directions, remember the solenoids cannot be energized at the same time in order to prevent the solenoids from burning.
● There is a protector of over-current between electrical control system and solenoid, in order to prevent the solenoid and the electrical component from burning in improper conditions.
Explanation Of Sample
● If client have special requirements,we can adjust the connect dimension ,power connect method and the extended length of push pin as demanding.
● Characteristic curve for reference only.
● The main performance parameter is obtained in the conditions of lab.Finally explanation and changing of the parameters by KAIDI.
