MFJ12-27/54 YC AC wet type electromagnet for valve-Rexroth type switch electromagnet-Product Center-Anyang kaidi Electromagnetic Technology Co.,ltd.

Current location: Home >Rexroth type switch electromagnet

Product Center

MFJ12-27/54 YC AC wet type electromagnet for valve

Introduction

PurposeThis series solenoid is applied to the contro circuits of AC 50Hz, which voltage can reach 380V, as a power component of the hydraulic solenoid directional valve. It can be used in NG6, NG10 screw connected solenoid directional valve of REXROTH.Usual Service Conditions● It can be installed randomly.● There is no gas or dust which can corrupt metal or destroy nonconductor. Or, it will affect

National Service Hotline:

+86-372-2595077/2595078/2595088

Online consultation

Purpose

This series solenoid is applied to the contro circuits of AC 50Hz, which voltage can reach 380V, as a power component of the hydraulic solenoid directional valve. It can be used in NG6, NG10 screw connected solenoid directional valve of REXROTH.

Usual Service Conditions

● It can be installed randomly.

● There is no gas or dust which can corrupt metal or destroy nonconductor. Or, it will affect the products lifetime.

● The solenoids fit for the continuous duty system or intermittent periodic duty system.

● The reasonable wave range of supply voltage is between 85%-110%(any special requirements is possible).

● The protection is IP65 class.

Key Parameters

Code	MFJ12-27YC	MFJ12-54YC
Rated Voltage (V)	110220	110220
Power Frequency (Hz)	50	50
Rated Force (N)	≥27	≥54
Rated Stroke (mm)	2.8	4
Total Stroke (mm)	≥6.1	≥9
Static Oil Pressure (MPa)	21	21
Starting volt ampere (VA)	≤154	≤308
Suction voltammetry (VA)	≤58	≤78
Operating Frequency (T/h)	12000	12000

Order Code

Valve-Using Solenoids	AC	Design Code	Rated Force(N)	Wet
MF	J	12	27/54	YC

Steady Stroke-Force Curve

info1

Externality &Installation Dimensions

MFJ12-27YC

info2

MFJ12-54YC

info3

Operating Notice

● The socket, which solenoids used, is according to ISO4400 standard. Including two specifications:indicator light &without light. You can choose according to your requirements. The voltage of the socket, with indicator light, must conform to the voltage of solenoid itself.

● The pushpin of the solenoid is used in adjustment or sometimes in emergency, but when the back pressure of the system is higher, please use screwdriver to push it, not strike it. The wallop can destroy the pushpin and the surface of the leading hole, or the solenoid will leak oil or cannot reposition.

● When the system ask for low noise, or the cleanliness of the oil can not make sure, or the wave range of the supply power is beyond common requirements, please use the Ac internal rectifying solenoid.

● When solenoid is used in double directions, remember the solenoids cannot be energized at the same time in order to prevent the solenoids from burning.

● There is a protector of over-current between electrical control system and solenoid, in order to prevent the solenoid and the electrical component from burning in improper conditions.